Hanging bauble Christmas card
- A4 Sheet Iceberg Card (each sheet will give you 1 card)
- A4 Sheet Hanging Baubles Sheer Paper (each sheet will give you 1 card)
- Roll of Gold, Red or Green Ribbon
- DL Iceberg Envelopes
- Paper trimming method of choice
- Pencil and ruler
- 1/8” round hole punch
- Vellum tape
Using preferred trimming method cut the A4 Iceberg card to 210mm x 200mm.
Using preferred scoring method score the card in half along the long edge to create a fold at 100mm.
Using preferred trimming method cut the Hanging Baubles sheer paper into 200mm wide x 210mm, making sure that the baubles are hanging down.
Lay the Iceberg card flat. Apply a small strip of vellum tape to the right of the score mark, what will be the front of the card. Position the Hanging Baubles sheer paper over the card being careful to align the sheets. Press firmly to achieve maximum adhesion. Fold the card in half.
Using pencil and ruler, mark two dots, approximately 25mm from the top edge and 35mm from the fold and right hand edge of the card. Using a 1/8” round hole punch, punch two holes where you have marked, making sure both layers are unched through.
Cut the ribbon into 45cm lengths. Thread the ribbon through both holes, being careful to pass through both layers of paper and tie a bow.
Write your Christmas greetings on the inside of the card. Insert completed card into the DL Iceberg envelope and seal using the matching Hanging Bauble seal for that perfect finishing touch.
Tips and tools
Christmas card etiquette
Find instructions for beginner Christmas card projects
Find instructions for intermediate Christmas card projects
Browse all Christmas ideas, activities and recipes